What Happens When Reglazing Your Bathtub Goes Wrong? 

Getting a tub reglazing job done is an excellent way to restore the original beauty of your bathtub, but it can also create other problems. If the bathtub has not been properly prepared or is over-catalyzed, it is possible to have bubbles or other issues with the finished coat. It is also important to understand how much coating is recommended for your specific surface. 

(Searching in Google “cleaning ceramic tile“? Contact us today!)

Reglazing your bathtub is a relatively simple process, but you should be aware of the limitations of your chosen paint or coating. You can avoid some common problems if you know what to expect. 

One of the most common reasons for resurfacing to go wrong is the improper preparation of the surface. This can cause uneven areas and cracking. The coating can also fail to cure properly. Having the right amount of sandpaper can prevent this problem. Once the sanding is done, it is imperative that the tub is blown dry. 

Another problem is excess build-up on the surface of the tub. A rough texture can occur when a refinishing contractor sprays too much coating. To fix this, a professional technician can apply a coat of 1500 grit sand to the surface. After the sanding is completed, the resurfacer should wait 24 hours for the coating to cure. 

Bubbles can also happen if the resurfacer does not allow the coating to fully cure. When this happens, the air gets trapped between the layers. In this case, the refinishing company may need to apply another layer of paint. 

Getting a tub reglazing job wrong can be a huge headache. However, it is not something that will always happen. With proper care, your reglazed tub should last for years. Even if the job is done poorly, it is still better than replacing the tub. 

During the process, a refinishing contractor needs to make sure that the tub is in good condition. The tub must be free from dust, dirt, and debris. It is also advisable to take measurements of the tub so that the job is done correctly. 

Ensure that the refinishing company you choose has a good reputation. Before you hire a company, you should check to see if they have a warranty. Choosing a company with a warranty will ensure that you get a quality job that will not cause any issues down the road. 

Reglazing bathtubs is a quick, inexpensive way to restore the look and feel of your bathtub. However, it can also be dangerous. Many bathtub reglazing jobs go wrong because the refinishing technician does not follow the manufacturer’s specifications. By following these instructions, you can be sure that the coating will adhere to the surface and that your bathtub will not become damaged. 

Unlike resurfacing, reglazing a bathtub is only a cosmetic fix. Your tub will still need to be replaced if it has structural cracks, rust, or other deteriorating issues. Additionally, resurfacing can only mask the problem for a while, whereas a replacement can remedy the problem permanently.