How to Drill Through Porcelain Tile?

Getting through porcelain tile can be a real challenge. The tile itself is dense and slippery, making it difficult to drill. Drilling through the tile is also a risky process, as you can easily crack or shatter the tile. To avoid this, you must make sure that you use the correct tools. 

(Searching in Google “bathroom countertops near me“? Contact us today!)

First, you must mark the area where you will be drilling. This can be done with masking tape. This will keep the drill from slipping and will help you to keep your measurements accurate. A whiteboard marker is also useful. This will help you to create a dot on the wall where you will be drilling. 

Next, you need to use the correct type of drill bit. This is usually a diamond-tipped drill bit. These are more expensive than carbide-tipped drill bits, but they will help you to drill through porcelain tile without damaging it. Diamond-tipped drill bits also don’t burn out as quickly as masonry bits. You should also wear a safety mask and safety goggles. 

It is important to keep the drill steady when drilling through porcelain tile. This will prevent it from skidding and cracking. Excessive speed and pressure can also damage the tile. In addition, using a hammer-style drill can cause cracks to form in the tile. This is why it is important to use a rotary-style drill. 

After you have marked the area, use the drill guide to put the drill bit into place. You should also use masking tape to prevent your drill bit from slipping. This is also a good way to see if you are going to hit a boring spot. After you have put the drill guide in place, you should place the drill bit in the center of the mark. You can then remove the drill guide after two to three seconds. 

Next, you should use a sponge to keep your drill from overheating. Also, spraying the tile with cold water will help to control the heat. This will also help you to catch any dust that might have been thrown up by the drill. 

You can also use painter’s tape to help with traction and keep your drill from slipping. This will also prevent the drill from meandering. You can also use the tape to create a cross in the drill hole. It will also prevent a sticky residue from forming. 

You can also use an extension cable, but be sure that the cable is not a strangulation hazard. You should also wear latex-gripping safety gloves. 

If you have trouble drilling through porcelain tile, it is a good idea to hire a professional. A seasoned handyman can give you advice on how to get through the tile, as well as help you avoid common mistakes. You might also be able to find a video online that shows you how to drill through a 6mm-diameter hole in porcelain tile. 

To keep the drill bit from skidding, it is important to keep the speed of the drill very low. The speed should be set between 100 and 200 RPMs.