How Do You Clean the Overspray From Resurfacing a Bathtub? 

Before resurfacing your bathtub, you need to know how to clean up the overspray. This can be done by cleaning it using a solution or using a suction cup. Then, you should rinse the tub with hot water. 

(Looking for cheap bathroom countertops? Contact us today!)

Suction cups 

When resurfacing a bathtub, it’s important to know what products to avoid and which ones can damage the finish. You should avoid using high-alkaline cleaners or strong acids on the bathtub’s surface. These products can damage the coating and invalidate the warranty. In addition, you should never use the bathtub for storage of water. Products containing bleach, phosphoric acid, and pumice are dangerous and can damage the finish. Never use rubber bathmats in the tub as these can ruin the finish. 

Suction cups are another common tool used to clean the overspray of resurfacing a bathtub. While these products are effective in cleaning the overspray, they can damage the coating on the bathtub. This is why you should use a plastic or wooden caddy for them. 

Etching solutions 

During the resurfacing process, you’ll have to clean the bathtub thoroughly. A 2 step cleaning process begins with an etching solution, which is applied to the tub’s surface with a sponge or paint brush. You’ll want to leave it on the bathtub for 15 to 20 minutes, and then rinse it off with warm water. 

Unlike the chemical bonding method, which doesn’t require etching or priming, a mechanical bonding process requires two steps: etching and priming. The etching solution needs to create a porous surface before you can apply the new coating. You’ll also need to apply a bonding agent. The two processes should be performed together to get the best adhesion. 

Laundry detergent 

Laundry detergent is one of the main components of an effective cleaning solution. It helps remove dirt and soap scum residue. It can be used as either liquid detergent or powder to scrub away hard stains. The powder can be mixed with water to create a thick paste. Then, it can be applied directly to the stained area and allowed to dry for about 20 minutes before it can be rinsed off. 

The overspray left by resurfacing a bathtub can be cleaned with laundry detergent. This solution is safe for acrylic and will clean the paint residue without harming the surface. Ideally, the solution should contain two or three ounces of detergent per inch of water. 

Cleaning solutions 

If you are resurfacing your bathtub, the first step is to thoroughly clean it. This is the most important step since it will remove the years of buildup. Pay special attention to the drain. This will maximize the durability of the new finish. After cleaning, you should inspect the bathtub to make sure that there are no remaining patches of buildup. 

Then, you should apply the cleaner generously. To do this, use a cellulose sponge or dish soap and apply it evenly on the tub’s surface. Once you’ve applied the cleaner, scrub it in with a microfiber cloth. You can also scrub the non-slip surfaces using a soft nylon-bristle brush.